Levolor uses four different headrail colors designed to coordinate with over thirty different slat finishes. After the valance is installed, the headrail will be covered and no longer visible.

For our custom Faux and Real Wood blinds, we recommend that you contact customer service to see if a repair to restring is available. If so, Customer Service will provide the repair costs and generate a repair order number.

Additional wood slats are available for purchase. To order, contact your local Levolor blind retailer or Levolor customer service. Before you order, take a minute to measure your blind. You’ll need to know the width of the slat, as well as the route hole measurements, starting from the left of the blind working to the right.

Locate the metal spears connected to the motor or cord loop clutch. Sometimes the small plastic component that keeps these spears from rubbing against the brackets moves out of position. Simply push this plastic component to the end of the metal spears to eliminate the noise.

To level the blind:

• Locate the lowest side of the bottom rail and raise it by turning the corresponding skew adjuster clockwise with a screwdriver while continuing to lift and support the bottom rail in a leveled position.

NOTE: Turn the skew adjuster that is on the same side as the low end of the bottom rail. Privacy route product will have skew adjusters on both the front and back of the head rail. Both must be adjusted to raise the bottom rail evenly.

Adjusting the Cordless Blind Height If the blind height is too long:

• Lift the bottom rail and turn all skew adjusters clockwise to raise the entire bottom rail to the desired height.
  NOTE: There is an adjustment range of approximately 1¼”.

Cord Stop

• This component breaks apart with minimal pressure, should a child or a pet become entangled in the top lift cords.
• It also acts as a stopper to prevent inner cords from being pulled through the blind which can also create potential entanglement

Reassembly of Cord Stop

• Reinsert any loose cords into the top notches of the cord stop. There is a notch on each side.
  Line up the two halves of the cord stop and snap the pieces back together.

Visit our cleaning and care page.

To view more technical information on Faux Wood Blinds such as fabric comparison, parts and components, and cleaning and care download the Technical Guide below.